This brake light is a better improvement from the original piece. The LED lights are much brighter, smaller, and much more defining which, gives it a better and bolder look to the back of the SUV. There is only one bad thing, I'm not sure if it is the molding piece where it comes through to be visible that kind of bends or shrinks with the environment elements, or if it is the length of the improved piece that might have been constructed a couple of millimeters longer, but extra careful must be used when installing it inside the molding if you don't want to snap, or put a crack on the molding trim itself (which is $350.00 by the way). During my challenge, I just carved the ends of the hole in the molding a hair wider to fit the new assembly. This is very easy and can be done with anything sharp, even with a pocket knife, just be careful not to get cut!!!I know that this design is an aftermarket and some alterations might have needed to get done, but for me, it's better to...