2010 Subaru Forester Engine Coolant Bypass Hose Parts
Image
Product
Price
- Molded Heater Hose
- Product Attributes:
- Branch Quantity: 0
- Molded: Yes
- Centerline Length:
- 124
- 4.9
- End 1 Inside Diameter:
- .63
- 16
- Material: Epdm
- End 2 Inside Diameter:
- .63
- 16
- Quick Connect Fitting Quantity: 0
-
Features:
- Has all the quality features of Gates molded coolant hose and similar to OEM specifications
- Engineered to resist electrochemical degradation – the leading cause of hose failure
- EPDM tube, synthetic fiber knit reinforcement, EPDM cover
- Meets SAE 20R3 Type EC Class D-1 and D-2 specifications
- Temperature Range: -40 Deg. F to 275 Deg. F (-40 Deg. C -135 Deg. C)
- Note: Gates recommends replacing hose clamps each time a new coolant hose is installed
- Caution: Do not use for fuel or oil transfer applications
- Gates Small I.D. Molded Coolant Hose is factory-molded, OEM style hose to fit today’s smaller, tighter-fitting engine compartments. It can be used for coolant, water and air applications, also approved for marine applications.
This Part Fits the Following OEM/Substitute Numbers:
11535, 14518S, 19535, 807615081, 87964, F10066
Additional Fitment Information:
| Vehicle | Block | CC | Position | Fuel Type | Engine | CID |
|---|---|---|---|---|---|---|
| 2010 - Subaru Forester | H | 2458 | Pipe-2 To Thermostat | GAS | 4 Cyl 2.5L | - |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle | Aspiration |
|---|---|
| 2010 - Subaru Forester | Naturally Aspirated |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Lower Water Pump Connector to Pipe. Lower Water Pump Connector to Pipe.
Additional Fitment Information:
| Vehicle | Aspiration |
|---|---|
| 2010 - Subaru Forester | Turbocharged |
Showing 1 - 3 of 3 products
Loading...