2006 Subaru Forester Engine Crankcase O Ring Parts

Showing 1 - 5 of 5 products
Image
SKU
Product
Rating
Price

Nippon Reinz
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • Between Crankcase Halves - 19.2 x 2.4mm O-Ring
  • 19.2 x 2.4mm O-Ring (Between Crankcase Halves)

Additional Fitment Information:
Vehicle
2006 - Subaru Forester

Ishino Stone
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • This is a Crankcase bolt sealing washer. This is a metal outer seal o-ring with a rubber seal inside. 19.5 mm OD

Additional Fitment Information:
Vehicle
2006 - Subaru Forester

Ishino Stone
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • Used between the crankcase halves at the lower second journal from the front - (OD is 39 mm)

Additional Fitment Information:
Vehicle
2006 - Subaru Forester

Ishino Stone
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • Aluminum washer for Plug on front and rear of Right Crankcase half and front of Left Crankcase half. (34mm OD.)
  • This is a aluminum washer to be used on the cylinder block plugs. 34mm OD.

Additional Fitment Information:
Vehicle
2006 - Subaru Forester

Genuine
  • This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
  • Aluminium washer for the large plugs on Crankcase

Additional Fitment Information:
Vehicle
2006 - Subaru Forester
Showing 1 - 5 of 5 products

Loading...