Image
Product
Price
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 1997 - Audi A4 | Rear Outer |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 1997 - Audi A4 | Rear Inner |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 1997 - Audi A4 | Rear Inner |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- 82mm O.D. 43mm I.D. This kit 4D0 407 625E has a Stepped (Two Different Inside Diameters) Wheel Bearing. 43mm and 45mm ID. Stepped Areas, Width 23mm w/43mm ID and 13mm Width, Overall Bearing Width 37mm and 82mm Outside Diameter.
Additional Fitment Information:
| Vehicle | Block | CC | Position | Engine | CID |
|---|---|---|---|---|---|
| 1997 - Audi A4 | V | 2771 | Front | 6 Cyl 2.8L | - |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- 75 x 37mm
- w/Bolt Only
Additional Fitment Information:
| Vehicle | Block | CC | Position | Engine | CID |
|---|---|---|---|---|---|
| 1997 - Audi A4 | L | 1781 | Front | 4 Cyl 1.8L | - |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle | Block | CC | Position | Engine | CID |
|---|---|---|---|---|---|
| 1997 - Audi A4 | V | 2771 | Front | 6 Cyl 2.8L | - |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle | Cylinder Head Type |
|---|---|
| 1997 - Audi A4 | SOHC |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Chas: -152 676, Required when replacing Brake Disc
- Rear
Additional Fitment Information:
| Vehicle | Position | Chassis Range |
|---|---|---|
| 1997 - Audi A4 | Rear | up to 152 676 |
Showing 1 - 8 of 8 products
Loading...