2018 Acura ILX Driveline and Axles Parts
Choose your Part Name for your 2018 Acura ILX
Image
Product
Price
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- This bearing is equipped with an internal ABS sensor magnet. Care must be taken during installation to insure that the sensor magnet is located on the correct side of the bearing housing. Failure to do so may cause a malfunction in the ABS system. For more info, refer to the appropriate section of your service manual or check with your local dealer.
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2018 - Acura ILX | Front |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2018 - Acura ILX | Front |
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2018 - Acura ILX | Front Inner |
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2018 - Acura ILX | Front Inner |
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2018 - Acura ILX | Front Inner |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Wheel bearing is serviced separately.
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2018 - Acura ILX | Front |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Carrier bearing ONLY. This bearing is also included with the right inner half-shaft stub axle.
Additional Fitment Information:
| Vehicle |
|---|
| 2018 - Acura ILX |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2018 - Acura ILX | Front |
- Large
- This kit contains 2 universal clamps: 1 for the wide boot end and 1 for the narrow boot end (use 1 kit per boot).
- 1 large + 1 small clamp
- 1 Large + 1 Small Clamp
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2018 - Acura ILX | Front Inner |
- Preset, Pre-Greased And Pre-Sealed Double Row Ball Bearing Assembly
- Timken bearing assemblies are pre-set, pre-greased and pre-sealed for ease of installation
-
Suggested Purchase Quantity: 2
- Most jobs typically require 2 of this item.
Additional Fitment Information:
| Vehicle | Position | Drive Type |
|---|---|---|
| 2018 - Acura ILX | Front | FWD |
Showing 1 - 10 of 48 products
Loading...