1990 Volvo 240 Emission Control Parts
Choose your Part Name for your 1990 Volvo 240
Engine Crankcase Breather Hose
Exhaust Gas Recirculation (EGR) Valve
Exhaust Gas Recirculation (EGR) Valve Gasket
Exhaust Gas Recirculation (EGR) Valve Temperature Sensor
Flame Trap
Flame Trap Hose
Flame Trap Kit
Flame Trap Nipple
Ignition Knock (Detonation) Sensor
Oxygen Sensor
PCV Valve Hose
PCV Valve O-Ring
PCV Valve Oil Trap
PCV Valve Oil Trap Seal
Throttle Position Sensor
Vacuum Hose
Vacuum Hose Connector
Vacuum Regulator Valve
Image
Product
Price
Additional Fitment Information:
| Vehicle |
|---|
| 1990 - Volvo 240 |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- 34mm ID x 3mm - Oil Trap to Engine Block This O-Ring may be used in a few different locations on many vehicles, including : Distributor to engine block and Oil Trap to engine block.
- 34.2 X 3
Additional Fitment Information:
| Vehicle |
|---|
| 1990 - Volvo 240 |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- 34mm ID x 3mm - Oil Trap to Engine Block This O-Ring may be used in a few different locations on many vehicles, including : Distributor to engine block and Oil Trap to engine block.
- 34.2 X 3
Additional Fitment Information:
| Vehicle |
|---|
| 1990 - Volvo 240 |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- 34mm ID x 3mm - Distributor to Engine Block This O-Ring may be used in a few different locations on many vehicles, including : Distributor to engine block and Oil Trap to engine block.
- 34.2 X 3
Additional Fitment Information:
| Vehicle |
|---|
| 1990 - Volvo 240 |
- Below Flame Trap Assembly
- When replace oil trap, order O-ring # 949659 as needed.
Additional Fitment Information:
| Vehicle |
|---|
| 1990 - Volvo 240 |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Miscellaneous Vacuum Lines
Additional Fitment Information:
| Vehicle |
|---|
| 1990 - Volvo 240 |
- 90 Deg. fitting with same diameter holes on both ends - small. Quanitity per car as needed. Also used when replacing earlier version #1259327 Heater Valve.
Additional Fitment Information:
| Vehicle |
|---|
| 1990 - Volvo 240 |
- When replacing this Valve on a vehicle that is not equipped with a ECT Sensor, it may be necessary to install a Plug (part # 977926) and a Seal Ring (part # 947281) in the ECT sensor port.
Additional Fitment Information:
| Vehicle | Transmission |
|---|---|
| 1990 - Volvo 240 | Automatic |
Additional Fitment Information:
| Vehicle |
|---|
| 1990 - Volvo 240 |
Additional Fitment Information:
| Vehicle |
|---|
| 1990 - Volvo 240 |
Showing 1 - 10 of 26 products
Loading...