1983 Volvo 760 Transmission Parts
Choose your Part Name for your 1983 Volvo 760
Automatic Transmission Drain Plug Seal
Automatic Transmission Extension Housing Bushing
Automatic Transmission Extension Housing Gasket
Automatic Transmission Extension Housing Seal
Automatic Transmission Filter O-Ring
Automatic Transmission Overdrive Solenoid O-Ring
Automatic Transmission Seal
Automatic Transmission Selector Shaft Seal
Automatic Transmission Shift Linkage Bushing
Clutch Cable
Clutch Master Cylinder
Clutch Pilot Bearing
Manual Transmission Output Shaft Seal
Manual Transmission Overdrive Solenoid Seal
Transmission Drain Plug
Transmission Filter Gasket
Transmission Filter Kit
Transmission Oil Filter
Transmission Oil Pan Gasket
Image
Product
Price
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Pump Input Seal
- 55mm
Additional Fitment Information:
| Vehicle | Block | CC | Position | Engine | CID |
|---|---|---|---|---|---|
| 1983 - Volvo 760 | V | 2849 | Front | 6 Cyl 2.8L | - |
Additional Fitment Information:
| Vehicle | Block | CC | Engine | CID |
|---|---|---|---|---|
| 1983 - Volvo 760 | V | 2849 | 6 Cyl 2.8L | - |
- Shifter at Control Rod or Control Rod at Transmission
- auto trans
Additional Fitment Information:
| Vehicle | Block | CC | Engine | CID |
|---|---|---|---|---|
| 1983 - Volvo 760 | V | 2849 | 6 Cyl 2.8L | - |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Pump Input Seal
Additional Fitment Information:
| Vehicle | Block | CC | Position | Engine | CID |
|---|---|---|---|---|---|
| 1983 - Volvo 760 | V | 2849 | Front | 6 Cyl 2.8L | - |
- Extension Housing Gasket
Additional Fitment Information:
| Vehicle | Block | CC | Engine | CID |
|---|---|---|---|---|
| 1983 - Volvo 760 | V | 2849 | 6 Cyl 2.8L | - |
- Problems with the installation of this part are usually due to failure to follow proper repair procedures. Use only a bushing extractor (NEVER A CHISEL!!!) to remove the old bushing. Measure the inside diameter of the housing (it should be 0.004"-0.005" smaller that the O/D of the bush for proper crush). Gently use a brake cylinder hone to enlarge the housing I/D if necessary. Install the new bushing only with the proper bushing driver! NEVER, EVER, USE A HAMMER & SOCKET TO INSTALL THIS BUSHING!!!
Additional Fitment Information:
| Vehicle | Block | CC | Engine | CID |
|---|---|---|---|---|
| 1983 - Volvo 760 | V | 2849 | 6 Cyl 2.8L | - |
- Gear Selector Cross-Shaft
Additional Fitment Information:
| Vehicle | Block | CC | Engine | CID |
|---|---|---|---|---|
| 1983 - Volvo 760 | V | 2849 | 6 Cyl 2.8L | - |
Additional Fitment Information:
| Vehicle | Block | CC | Engine | CID |
|---|---|---|---|---|
| 1983 - Volvo 760 | V | 2849 | 6 Cyl 2.8L | - |
- Shifter Stay Bushing at Tailshaft Housing
Additional Fitment Information:
| Vehicle | Engine Designation |
|---|---|
| 1983 - Volvo 760 | D24T |
Additional Fitment Information:
| Vehicle | Block | CC | Engine | CID |
|---|---|---|---|---|
| 1983 - Volvo 760 | V | 2849 | 6 Cyl 2.8L | - |
Showing 1 - 10 of 30 products
Loading...