Image
Product
Price
- Motor without Washer Pump
- Remanufactured Windshield Wiper Motor
- Product Attributes:
- FAQ_Q5: How Do Moisture Sensitive Wipers Work?
- FAQ_Q4: How Can I Determine If My Vehicle Is Equipped With A Moisture Sensitive Wiper Motor?
- Connector Gender: Female
- FAQ_Q1: The Wiper Motor Continues To Stop In The Middle Of The Windshield. What’s Causing This To Happen?
- FAQ_Q3: Why Won’t The Wiper Motor Work? I Have Everything Hooked Up Properly.
- FAQ_Q2: I Just Installed A New Wiper Motor And Put My Old Washer Pump On And The Motor Does Not Work. Is The Motor Defective?
- Washer Pump Included: No
- Is Prop Sixty Five Affected: No
- Product Condition: Remanufactured
- Is the item CARB affected: No
- Contains Electronic Components: Electric Motor
- Is Item A Chemical: No
- Material: Cast Aluminum
- Is Or Contains A Battery: No
- FAA_A4: Most Vehicles Equipped With This Feature Have A Rain Sensor Permanently Mounted To The Inside Of The Windshield In Front Of The Rear View Mirror.
- FAA_A5: A Moisture Sensor Monitors Rainfall Accumulation On The Windshield And Provides Input To The Windshield Wiper Motor Control Module. The Windshield Wiper Control Module Adjusts The Wiper Motor Speed Accordingly.
- Mounting Hole Quantity: 3
- FAA_A2: The Motor Is Not Defective. There Are Some Wiper Motors That Will Not Operate If The Washer Pump Is Defective. This May Be The Cause Of The Original Motor Problem. Bench Test Wiper Motor And Washer Pump Before Replacing Either.
- Terminal Quantity: 4
- Wiper Speeds: 2
- FAA_A3: Check The Wiring Harness Ground, Terminal Ground Lug Or Ground Strap. If The Motor Still Does Not Operate Properly, Check The Switch And Switch Circuit.
- FAA_A1: If The Motor Does Not Have Hidden Wiper Blades, The Most Likely Cause Of Parking Misalignment Is The Crank Arm Position. Adjust The Crank Arm Angle On The Motor Shaft To Park Wipers At Bottom Of Windshield. Refer To A Vehicle Specific Service Manual Or On
- Is Or Contains A Bulb: No
- Wiring Harness Included: No
- Does it require SDS: No
- Terminal Type: Blade
- Terminal Gender: Male
- Mounting Type: Direct Bolt
-
Features:
- Each unit has its main components tested or gauged against the O.E. standard. [Armature, Field, Bearing, Parking switch, or pulse board] – Then the final product is tested for each of its functions on the vehicle.
- Every motor bearing is re-impregnated or replaced as needed.
- Lubrication is applied to the output gear to provide maximum load capacity and long life.
- Weak solder points are 100% reflowed to extend life expectancy.
- Motor magnets are 100% recharged for performance and reliability.
- As a remanufactured Original Equipment part, this unit guarantees a perfect vehicle fit.
- Our remanufacturing process is earth-friendly, as it reduces the energy and raw material needed to make a new part by 80%.
- CARDONE's legacy began in 1970 when its first product offering was released − Remanufactured Wiper Motors. Since then, the CARDONE name has become synonymous with high-quality, remanufactured products. Every CARDONE wiper motor is re-engineered, built and tested to match O.E. performance. For nearly half a century, CARDONE Remanufactured Wiper Motors have provided rock-s olid reliability that you can trust for the long haul.
This Part Fits the Following OEM/Substitute Numbers:
22664679, 22664679
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2005 - Chevrolet Cobalt | Front |
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2005 - Chevrolet Cobalt | Front |
- Reman Complete Long Rack
- with Soft Ride Suspension (FE1)
- w/o Outer Tie Rod Ends
Additional Fitment Information:
| Vehicle | Sub Model |
|---|---|
| 2005 - Chevrolet Cobalt | LT |
- Reman Complete Long Rack
- with Soft Ride Suspension (FE1)
- w/o Outer Tie Rod Ends
Additional Fitment Information:
| Vehicle | Sub Model |
|---|---|
| 2005 - Chevrolet Cobalt | LT |
Additional Fitment Information:
| Vehicle | Sub Model | Body |
|---|---|---|
| 2005 - Chevrolet Cobalt | LT | Sedan |
Additional Fitment Information:
| Vehicle |
|---|
| 2005 - Chevrolet Cobalt |
- Cardone/OEF3 Reman
- Friction Ready - with Installation Hardware w/o Bracket
- Unloaded w/o Bracket
Additional Fitment Information:
| Vehicle | Position | Sub Model |
|---|---|---|
| 2005 - Chevrolet Cobalt | Front Left | LS |
- Cardone/OEF3 Reman
- Friction Ready - with Installation Hardware w/o Bracket
- Unloaded w/o Bracket
Additional Fitment Information:
| Vehicle | Position | Sub Model |
|---|---|---|
| 2005 - Chevrolet Cobalt | Front Right | LS |
Additional Fitment Information:
| Vehicle | Block | CC | Engine | CID |
|---|---|---|---|---|
| 2005 - Chevrolet Cobalt | L | - | 4 Cyl 2.0L | 122 |
Showing 1 - 9 of 9 products
Loading...