Image
Product
Price
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Club Sport Model
Additional Fitment Information:
| Vehicle | Sub Model |
|---|---|
| 1996 - Porsche 911 | Targa |
- An alternative to the modification described in Porsche Technical Bulletin Group 3, #8902, book "F" page 71. This kit solves the problem of sticking and binding needle bearings used in the original design of the the release bearing shaft. Kit includes 2, OILITE bronze bushings (self lubricated),a new heat treated shaft and instructions. No machining or special tools to buy. Updated version, all G50 and G64 Gear boxes.
- Bearing Shaft
Additional Fitment Information:
| Vehicle |
|---|
| 1996 - Porsche 911 |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Clutch Slave
Additional Fitment Information:
| Vehicle |
|---|
| 1996 - Porsche 911 |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Clutch Hydraulic System Pressure Accumulator
Additional Fitment Information:
| Vehicle | Sub Model |
|---|---|
| 1996 - Porsche 911 | Turbo |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- (Axle Flange) (50x80x20 Taper Roller)
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 1996 - Porsche 911 | Right |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Clutch Fork "Open Bearing"
Additional Fitment Information:
| Vehicle |
|---|
| 1996 - Porsche 911 |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- M8 x 40mm - Pan Head Screw
- M8 x 40mm
Additional Fitment Information:
| Vehicle | Sub Model |
|---|---|
| 1996 - Porsche 911 | Carrera 4 |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Joint Flange Rear Differential Drive Axle Seals (48x68x10)
- 48 X 68 X 10mm
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 1996 - Porsche 911 | Rear |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Clutch Fork
- Seal 13.02 X 16.4mm
Additional Fitment Information:
| Vehicle | Sub Model |
|---|---|
| 1996 - Porsche 911 | Turbo |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle | Position | Sub Model |
|---|---|---|
| 1996 - Porsche 911 | Front | Carrera 4S |
Showing 1 - 10 of 69 products
Loading...