1985 BMW 528e Fuel Injection Throttle Body Mounting Gasket Goetze
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle |
|---|
| 1985 BMW 528e |
- FREE SHIPPING on order over $100 USD shipped from same warehouse
- FULL WARRANTY
-
Order 24/7Order online anytime
-
100% SafetyOnly secure payments
-
Hot OffersDiscounts up to 90%
Goetze
Goetze an original equipment manufacturer and supplier of metal engine components, gaskets, piston rings and as well as a broad range of sealing solutions.
Goetze an original equipment manufacturer and supplier of metal engine components, gaskets, piston rings and as well as a broad range of sealing solutions.
Packaging
length
4.00
width
3.00
height
0.10
weight
0.01
Information on technical characteristics, the delivery set, the country of manufacture and the appearance
of the goods is for reference only and is based on the latest information available at the time of publication.
-
![]()
This gasket (well, seal, technically) fit my 1995 740i just like the stock part. I couldn't find torque values for the throttle body to intake bolts, but BMW says that M6 fasteners should be 10 Newton-meters (that's about 88 inch-lbs), and the M6-25 bolts felt about right at that setting with some anti-seize applied.I also replaced the six throttle body bolts with stainless socket-head cap screws, because two of the torx screws stripped while removing (I'm pretty sure it had never been apart, and the bolts were somewhat corroded). Be prepared with some small vice grips and a bolt extractor.
Related Products
Loading...