Image
Product
Price
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Installation note: Bearing has a red seal side and a black seal side. Black seal should face inward towards center of the car.
Additional Fitment Information:
| Vehicle | Position | Body |
|---|---|---|
| 2007 - BMW 328i | Rear | Convertible |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Gen 3
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2007 - BMW 323i | Front |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle | Position | Body |
|---|---|---|
| 2007 - BMW 328i | Rear | Sedan |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Gen 2
Additional Fitment Information:
| Vehicle | Position | Sub Model |
|---|---|---|
| 2007 - BMW Z4 | Front | Roadster 3.0si |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Note installation direction of Wheel Bearing. The red Sealing Ring must face outwards; otherwise ABS function is not assured by the Pulse Generator integrated in the bearing. Part should be installed using factory tool 33 3 260 to insure correct installation.
- Rear
Additional Fitment Information:
| Vehicle | Position | Sub Model |
|---|---|---|
| 2007 - BMW Z4 | Rear | M Coupe |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2007 - BMW 525xi | Front |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Must also replace (4) 31 12 6 760 203 hex bolt with washer
- Per BMW, when replacing hub assembly, (4) 31 12 6 760 203 hex bolt with washer are required.
- Gen 3
- Front with Bearing
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2007 - BMW M6 | Front |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Must also replace (4) 31 20 6 779 384 hex bolts with washers
- Gen 3
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2007 - BMW 530i | Front |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Also Required: (4) 33 32 6 764 563 Collar Screw and (1) 33 41 1 133 785 Axle Nut
- with Axle Nut
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2007 - BMW 525xi | Rear |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2007 - BMW 750Li | Rear |
Showing 1 - 10 of 14 products
Loading...