Image
Product
Price
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- O-Ring
Additional Fitment Information:
| Vehicle | Sub Model |
|---|---|
| 1991 - Honda Prelude | Si ALB |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle | Sub Model |
|---|---|
| 1991 - Honda Prelude | 2.0 Si |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 1991 - Honda Accord | Left |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Electronic Air Control Valve
Additional Fitment Information:
| Vehicle |
|---|
| 1991 - Honda Civic |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- This head bolt should be used during normal head gasket replacement. Please refer to Honda service bulletin 97-047 for additional info. It advises that if the head gasket is not leaking and is being changed for other reasons, this is the correct head bolt. If the head gasket is being replaced because of leakage, use special 90005-PM3-004 head bolts along with head gasket #12251-P01-004. Refer to the service bulletin for additional installation instructions for gasket #12251-P01-004.
- 10x140mm - Includes Washer
Additional Fitment Information:
| Vehicle |
|---|
| 1991 - Honda CRX |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Oil filter holder at engine (threaded fitting).
Additional Fitment Information:
| Vehicle | Engine Designation | Sub Model |
|---|---|---|
| 1991 - Honda Accord | F22A6 | EX |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Shock Absorber Bolt
- 12x98mm
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 1991 - Honda Accord | Front Lower |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- 19mm (3/4") wide; 20 meter (65 1/2 ft.) roll. This electrical tape is treated with capsaicin to reduce the incidence of wiring damage from mice (and other rodents) chewing on the wire insulation.
- Rodent Deterrent
Additional Fitment Information:
| Vehicle |
|---|
| 1991 - Honda CRX |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle | Position | Sub Model |
|---|---|---|
| 1991 - Honda Civic | Front | Base |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle |
|---|
| 1991 - Honda Prelude |
Showing 1 - 10 of 181 products
Loading...