Image
Product
Price
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle |
|---|
| 1986 - Mitsubishi Starion |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- 25.5 x 20 x 2.5
Additional Fitment Information:
| Vehicle |
|---|
| 1986 - Subaru DL |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Production: 08/19/1985-
Additional Fitment Information:
| Vehicle | Prod. Date Range |
|---|---|
| 1986 - Hyundai Pony | Fr:08-19-85 |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Production: 08/20/1985-
Additional Fitment Information:
| Vehicle | Prod. Date Range |
|---|---|
| 1986 - Hyundai Stellar | Fr:08-20-85 |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- 30x45x8mm.
Additional Fitment Information:
| Vehicle | Block | CC | Engine | CID |
|---|---|---|---|---|
| 1986 - Isuzu Trooper | L | 2254 | 4 Cyl 2.3L | - |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Production: 11/1986-
Additional Fitment Information:
| Vehicle | Position | Prod. Date Range |
|---|---|---|
| 1986 - Isuzu Trooper | Front | Fr:11-00-86 |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Rear Muffler Inlet
Additional Fitment Information:
| Vehicle |
|---|
| 1986 - Mitsubishi Galant |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Outside of the Bearing Carrier (There are two Inner Seals)
Additional Fitment Information:
| Vehicle | Position | Drive Type |
|---|---|---|
| 1986 - Subaru GL-10 | Rear Inner | 4WD |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Rotor Oil Seal O Rings, Front and Rear Main Seals Sold Separately Water Pump Spacer must be reused.
Additional Fitment Information:
| Vehicle |
|---|
| 1986 - Mazda RX-7 |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Located at top of Fuel Injector.
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 1986 - Mazda 323 | Upper |
Showing 1 - 10 of 157 products
Loading...