Image
Product
Price
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- This gasket set contains 1 valve cover gasket and 7 sealing washers.
Additional Fitment Information:
| Vehicle |
|---|
| 1993 - Mazda B2200 |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- For Variable Resonance Induction System (VRIS)
- Green and White 4mm Hose Barb
Additional Fitment Information:
| Vehicle | Sub Model |
|---|---|
| 1993 - Mazda MX-3 | SE |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- For Vacuum Chamber
- Green and White 4mm Hose Barb
Additional Fitment Information:
| Vehicle |
|---|
| 1993 - Mazda MPV |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- For Transfer Case
- Green and White 4mm Hose Barb
Additional Fitment Information:
| Vehicle | Drive Type |
|---|---|
| 1993 - Mazda MPV | 4WD |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Green and White Check Valve
- Green and White 4mm Hose Barb
Additional Fitment Information:
| Vehicle |
|---|
| 1993 - Mazda RX-7 |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- When changing valve lifters, it is recommended that the lifters are allowed to "settle/seat" for a minimum of 30 minutes to allow excess oil to drain. If this recommendation is not followed, some valves will make contact with the piston, resulting in the valve to break at the collet groove. It is also ideal if the engine is allowed to rest over night before starting the engine for the first time. If possible, the engine should be hand cranked or turned by hand the first time.
- Lash Adjuster
Additional Fitment Information:
| Vehicle |
|---|
| 1993 - Mazda 323 |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle | Sub Model |
|---|---|
| 1993 - Mazda MX-3 | GS |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Firewall Side
Additional Fitment Information:
| Vehicle | Block | CC | Position | Engine | CID |
|---|---|---|---|---|---|
| 1993 - Mazda 626 | V | 2497 | Right | 6 Cyl 2.5L | - |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Rear - Right
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 1993 - Mazda Miata | Rear Right |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 1993 - Mazda Miata | Rear Left |
Showing 1 - 10 of 17 products
Loading...