Image
Product
Price
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2014 - Honda Ridgeline | Front Right |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2014 - Honda Pilot | Right |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- This bearing is equipped with an internal ABS sensor magnet. Care must be taken during installation on vehicles with ABS to insure that the sensor magnet is located on the correct side of the bearing housing. Failure to do so may cause a malfunction in the ABS system. For more info, refer to the factory service information or check with your local dealer.
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2014 - Honda CR-V | Front |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle | Block | CC | Position | Engine | Sub Model | CID |
|---|---|---|---|---|---|---|
| 2014 - Honda Accord | V | 3471 | Right | 6 Cyl 3.5L | EX-L | - |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle | Block | CC | Transmission | Position | Engine | Body | CID |
|---|---|---|---|---|---|---|---|
| 2014 - Honda Accord | V | 3471 | Manual | Right | 6 Cyl 3.5L | Coupe | - |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Carrier bearing for inboard axle half shaft assembly.
Additional Fitment Information:
| Vehicle | Transmission | Position | Engine Designation |
|---|---|---|---|
| 2014 - Honda Accord | Automatic CVT | Front | J35Y2 |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- This bearing is equipped with an internal ABS sensor magnet. Care must be taken during installation to insure that the sensor magnet is located on the correct side of the bearing housing. Failure to do so may cause a malfunction in the ABS system. For more info, refer to the appropriate section of your repair manual or check with your local dealer.
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2014 - Honda Accord | Front |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- 78mm
Additional Fitment Information:
| Vehicle | Sub Model |
|---|---|
| 2014 - Honda Civic | Hybrid-L |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- 38x62x9mm
- Front
Additional Fitment Information:
| Vehicle |
|---|
| 2014 - Honda Ridgeline |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2014 - Honda Insight | Rear |
Showing 1 - 10 of 14 products
Loading...