Image
Product
Price
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle | Position | Sub Model |
|---|---|---|
| 2020 - Acura MDX | Front | SH-AWD |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Carrier bearing for inboard axle half shaft assembly.
Additional Fitment Information:
| Vehicle | Sub Model |
|---|---|
| 2020 - Acura RDX | SH-AWD |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- This bearing is equipped with an internal ABS sensor magnet. Care must be taken during installation to insure that the sensor magnet is located on the correct side of the bearing housing. Failure to do so may cause a malfunction in the ABS system. For more info, refer to the appropriate section of your repair manual or check with your local dealer.
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2020 - Acura TLX | Front |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- 3.5L
- 91mm
Additional Fitment Information:
| Vehicle | Position | Sub Model |
|---|---|---|
| 2020 - Acura MDX | Front | SH-AWD |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- 91mm
Additional Fitment Information:
| Vehicle |
|---|
| 2020 - Acura RLX |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- 91mm
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2020 - Acura TLX | Front |
Showing 1 - 6 of 6 products
Loading...