Image
Product
Price
- Tapered Roller Bearing Cone and Cup Assembly
- Both the inner (cone) and outer (cup) should be replaced at the same time to maximize reliability and life
-
Suggested Purchase Quantity: 2
- Most jobs typically require 2 of this item.
Additional Fitment Information:
| Vehicle | Position | Drive Type |
|---|---|---|
| 2004 - Mazda B3000 | Front Inner | RWD |
- Grease/Oil Seal
- Dana/Spicer 35 Axle
- Vent holes allow lubricants to flow freely around the seal lip - cooling seal components and removing heat build-up
Additional Fitment Information:
| Vehicle | Position | Drive Type |
|---|---|---|
| 2004 - Mazda B4000 | Front | 4WD |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Rear
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2004 - Mazda B4000 | Front |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Per Mazda, when replacing the Wheel Hub you must also replace the Axle Bolt part number 9YA0-21-083F, these bolts are not reusable (stretch type).
- Front
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2004 - Mazda 3 | Front |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle | Block | CC | Position | Engine | CID |
|---|---|---|---|---|---|
| 2004 - Mazda Tribute | L | 1989 | Rear | 4 Cyl 2.0L | 121 |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Inner
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2004 - Mazda B3000 | Rear Forward |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Inner
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2004 - Mazda B4000 | Front Rearward |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Includes Wheel Bearing and Studs
Additional Fitment Information:
| Vehicle | Position | BrakeABS |
|---|---|---|
| 2004 - Mazda 3 | Rear | Non-ABS |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- w/o Dynamic Stability Control (DSC)
- Includes Wheel Studs, Hub, ABS Sensor & Wheel Bearing.
- Front
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2004 - Mazda RX-8 | Front |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2004 - Mazda Tribute | Rear |
Showing 1 - 10 of 17 products
Loading...