Shop By Product Matching "Cardone"
Choose a Model for your 2008 Chevrolet
Image
Product
Price
- with Hydraulic Power Includes Inner Tie Rods For warranty purposes it is recommended to always install a filter and to use suggested OE Fluid and flush the system In-Line Filter available
- Remanufactured Rack and Pinion Assembly
- Product Attributes:
- FAQ_Q4: Are There Any Steps That Should Be Done Prior To Alignment?
- FAQ_Q1: I Replaced The Rack And Now The Power Steering Pump Is Whining. It Never Did This Before! What Happened?
- Grade Type: Regular
- Mounting Hardware Included: No
- FAQ_Q3: The Replacement Rack And Pinion Is Installed And The Steering Wheel Has Too Much Play. Should I Adjust The Rack?
- FAQ_Q2: The Steering Wheel Is Not Returning To Center Coming Out Of A Turn. What Could Be Causing This?
- Is Prop Sixty Five Affected: No
- Outlet Line Fitting Gender: Male
- End To End Length:
- 1393.82
- 54.875
- Product Condition: Remanufactured
- Is the item CARB affected: No
- Contains Electronic Components: No
- Steering Input Shaft Diameter:
- 0.785
- 19.93
- Mounting Brackets Included: No
- Type: Hydraulic
- Is Item A Chemical: No
- Total Turns Lock To Lock: 3
- Input Shaft Type: Double Flat
- Inlet Line Fitting Diameter:
- 0.462
- 11.73
- Is Or Contains A Battery: No
- FAA_A4: Yes, The Boot Clamps Must Be Loosened To Set The Toe Adjustment When Performing A Front-end Alignment. Failure To Loosen The Clamps Will Twist The Boots During Turning Maneuvers Causing Cracks To Form On Boot. Once The Boot Is Torn, Road Debris And Water
- Mounting Hole Quantity: 4
- FAA_A2: The Geometry Of The Front Suspension Is Designed To Return The Steering Wheel To Center Coming Out Of A Turn. If The Steering Wheel Is Not Returning To Center On Its Own When Coming Out Of A Turn, Check The Front-end Alignment Settings And Inspect For Bin
- FAA_A3: No. The Rack And Pinion Has Been Adjusted At The Factory. No Additional Adjustment Is Necessary. Try Isolating The Rack To Find Out Where The Play Exists. If You Hold The Inner Tie Rod And Have Someone Turn The Wheel, Does The Play Disappear? If So, The P
- FAA_A1: The Most Likely Cause Of A Power Steering Pump Whine Is Air In The System. The Steering System Must Be Bled. This May Take A Few Attempts Depending On The Design Of The System.
- Outer Tie Rods Included: No
- Is Or Contains A Bulb: No
- Gasket Or Seal Included: Yes
- Inlet Line Fitting Gender: Male
- Does it require SDS: No
- Inner Tie Rods Included: Yes
- Outlet Line Fitting Diameter:
- 0.451
- 11.46
- Bellows Color: Black
-
Features:
- Protective coating applied to each unit to extend the life of the unit (where applicable).
- 100% performance testing to ensure perfect fit, function and reliable performance.
- 100% hydraulic testing for proper flow, leakage and performance ensures perfect fit and function (where applicable).
- Racks are surfaced to precise specifications to prevent leaking between chambers and extend unit life.
- 100% new O.E.- style o-rings and lip seals ensure leak-free and long-lasting performance (where applicable).
- All new spool valve seals and rack donut seals are installed to eliminate internal leaks and ensure reliable performance (where applicable).
- Valve housings have polished micro-finish sleeves for durability (where applicable).
- As a remanufactured Original Equipment part, this unit guarantees a perfect vehicle fit.
- Our remanufacturing process is earth-friendly, as it reduces the energy and raw material needed to make a new part by 80%.
- CARDONE Remanufactured Rack & Pinions are re-engineered, built and tested to meet or exceed O.E. fit and performance. 100% new, O.E.-style o-rings and seals are installed to ensure leak-free, long-lasting performance. A final protective coating is applied and each unit is tested to guarantee a perfect fit and function.
This Part Fits the Following OEM/Substitute Numbers:
15254060, 15254062, 19133646 , 19133648, 19133648 , 19153072, 19153072 , 19153073, 19153074, 19153074 , 19153075, 19178559, 19178559 , 19178561, 19207489 , 19207490, 19207491, 19207491 ...VIEW MORE
Additional Fitment Information:
| Vehicle | Body |
|---|---|
| 2008 - Chevrolet Silverado 1500 | Crew Cab Pickup |
Additional Fitment Information:
| Vehicle |
|---|
| 2008 - Chevrolet Express 3500 |
- Cardone/OEF3 Reman
- HousingIncl.Piston,Piston Seal,Boot,Bleeder Valve & Cap
- Friction Ready - with Installation Hardware w/o Bracket
- Unloaded w/o Bracket
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2008 - Chevrolet Trailblazer | Rear Left |
- Cardone/OEF3 Reman
- HousingIncl.Piston,Seal,Boot,Bleeder & Cap
- Friction Ready - with Installation Hardware w/o Bracket
- Unloaded w/o Bracket
Additional Fitment Information:
| Vehicle | Position | Sub Model |
|---|---|---|
| 2008 - Chevrolet Trailblazer | Rear Left | SS |
- Motor without Washer Pump
- Remanufactured Windshield Wiper Motor
- Product Attributes:
- FAQ_Q5: How Do Moisture Sensitive Wipers Work?
- FAQ_Q4: How Can I Determine If My Vehicle Is Equipped With A Moisture Sensitive Wiper Motor?
- Connector Gender: Female
- FAQ_Q1: The Wiper Motor Continues To Stop In The Middle Of The Windshield. What’s Causing This To Happen?
- FAQ_Q3: Why Won’t The Wiper Motor Work? I Have Everything Hooked Up Properly.
- FAQ_Q2: I Just Installed A New Wiper Motor And Put My Old Washer Pump On And The Motor Does Not Work. Is The Motor Defective?
- Washer Pump Included: No
- Is Prop Sixty Five Affected: No
- Product Condition: Remanufactured
- Is the item CARB affected: No
- Contains Electronic Components: Electric Motor
- Is Item A Chemical: No
- Material: Cast Aluminum
- Is Or Contains A Battery: No
- FAA_A4: Most Vehicles Equipped With This Feature Have A Rain Sensor Permanently Mounted To The Inside Of The Windshield In Front Of The Rear View Mirror.
- FAA_A5: A Moisture Sensor Monitors Rainfall Accumulation On The Windshield And Provides Input To The Windshield Wiper Motor Control Module. The Windshield Wiper Control Module Adjusts The Wiper Motor Speed Accordingly.
- Mounting Hole Quantity: 3
- FAA_A2: The Motor Is Not Defective. There Are Some Wiper Motors That Will Not Operate If The Washer Pump Is Defective. This May Be The Cause Of The Original Motor Problem. Bench Test Wiper Motor And Washer Pump Before Replacing Either.
- Terminal Quantity: 4
- Wiper Speeds: 2
- FAA_A3: Check The Wiring Harness Ground, Terminal Ground Lug Or Ground Strap. If The Motor Still Does Not Operate Properly, Check The Switch And Switch Circuit.
- FAA_A1: If The Motor Does Not Have Hidden Wiper Blades, The Most Likely Cause Of Parking Misalignment Is The Crank Arm Position. Adjust The Crank Arm Angle On The Motor Shaft To Park Wipers At Bottom Of Windshield. Refer To A Vehicle Specific Service Manual Or On
- Is Or Contains A Bulb: No
- Wiring Harness Included: No
- Does it require SDS: No
- Terminal Type: Blade
- Terminal Gender: Male
- Mounting Type: Direct Bolt
-
Features:
- Each unit has its main components tested or gauged against the O.E. standard. [Armature, Field, Bearing, Parking switch, or pulse board] – Then the final product is tested for each of its functions on the vehicle.
- Every motor bearing is re-impregnated or replaced as needed.
- Lubrication is applied to the output gear to provide maximum load capacity and long life.
- Weak solder points are 100% reflowed to extend life expectancy.
- Motor magnets are 100% recharged for performance and reliability.
- As a remanufactured Original Equipment part, this unit guarantees a perfect vehicle fit.
- Our remanufacturing process is earth-friendly, as it reduces the energy and raw material needed to make a new part by 80%.
- CARDONE's legacy began in 1970 when its first product offering was released − Remanufactured Wiper Motors. Since then, the CARDONE name has become synonymous with high-quality, remanufactured products. Every CARDONE wiper motor is re-engineered, built and tested to match O.E. performance. For nearly half a century, CARDONE Remanufactured Wiper Motors have provided rock-s olid reliability that you can trust for the long haul.
This Part Fits the Following OEM/Substitute Numbers:
22664679, 22664679
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 2008 - Chevrolet Cobalt | Front |
- Reman Complete Long Rack
- w/o Outer Tie Rod Ends
Additional Fitment Information:
| Vehicle |
|---|
| 2008 - Chevrolet Uplander |
Additional Fitment Information:
| Vehicle |
|---|
| 2008 - Chevrolet Corvette |
Additional Fitment Information:
| Vehicle |
|---|
| 2008 - Chevrolet Uplander |
- Reman Complete Long Rack
- with Increased Capacity Package (RPO Z85)
- w/o Outer Tie Rod Ends
Additional Fitment Information:
| Vehicle | Drive Type |
|---|---|
| 2008 - Chevrolet Colorado | RWD |
- Reman Complete Long Rack
- with Sport Package (RPO ZQ8)
- w/o Outer Tie Rod Ends
Additional Fitment Information:
| Vehicle | Drive Type |
|---|---|
| 2008 - Chevrolet Colorado | RWD |
Showing 1 - 10 of 96 products
Loading...