Image
Product
Price
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- 2 bar low pressure and 30 bar high pressure binary switch. This switch is designed to be compatible with R-12 and R134a refrigerants. Located on reciever-drier with 2 spade terminals. Used for compressor cut-out.
Additional Fitment Information:
| Vehicle |
|---|
| 1993 - Porsche 928 |
Additional Fitment Information:
| Vehicle | Position | Aspiration |
|---|---|---|
| 1993 - Porsche 911 | Front | Turbocharged |
Additional Fitment Information:
| Vehicle | Position |
|---|---|
| 1993 - Porsche 911 | Left |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- A/C Series Resistor
Additional Fitment Information:
| Vehicle |
|---|
| 1993 - Porsche 911 |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Snowflake
Additional Fitment Information:
| Vehicle |
|---|
| 1993 - Porsche 968 |
- This Original Equipment Manufacturer part is the same part that was made & installed by the car manufacturer at the factory where the car was produced.
- Heat Exchanger to Control Valve From Heat Exchanger
- Cuffed on both ends to prevent un-ravelling.
- Heat Exchanger
Additional Fitment Information:
| Vehicle | Position | Aspiration |
|---|---|---|
| 1993 - Porsche 911 | Right | Naturally Aspirated |
Additional Fitment Information:
| Vehicle | Sub Model | Engine VIN | Aspiration |
|---|---|---|---|
| 1993 - Porsche 911 | Carrera 2 | B | Naturally Aspirated |
Showing 1 - 10 of 10 products
Loading...